ABAQUS Development: Writing of Creep Subroutine

ABAQUS Development: Writing of Creep Subroutine
Published 12/2025
Duration: 1h 3m | .MP4 1920×1080 30fps(r) | AAC, 44100Hz, 2ch | 1.08 GB

Step-by-step instruction on using the creep subroutine

What you’ll learn
– Introduction to Creep Concepts
– Introduction to the CREEP User Subroutine
– Model Debugging and Verification
– Two cases of the creep subroutine
– The idea of writing the creep subroutine

Requirements
– Understand the basic operations of Abaqus
– Have a basic understanding of the FORTRAN language

Description
During the course recording period, I suffered from illness which caused persistent coughing and severe hoarseness. To ensure that the audio quality remains clear, consistent, and free from distractions that could hinder students’ learning experience, I opted to use AI-powered translation and voice cloning technologies for the multi-language versions of the course. My primary goal was to deliver accessible, high-quality content that allows learners to focus on the course material without being disrupted by the temporary vocal impairments caused by my illness.
ABAQUS CAE is one of the most widely used Finite Element Analysis software in the world. ABAQUS was developed by Dassault SYSTEMS.

in this course, you will learn how to write ABAQUS creep subroutines.

the main content of this course is given below:

Introduction to Related Concepts

Introduction to the CREEP User Subroutine

Model Debugging and Verification

Finally, I wish you success in your studies and project.

Who this course is for:
– this course is for everyone who wants to learn Abaqus subroutines
– mechanical engineers
– Design engineers
– Master and PhD students
– Simulation Engineers
More Info